Download Excelsior-488

Transcript
Controls and Connections
(FEMALE)
(MALE)
Figure 16: Excelsior Controls and Connections
The only control for the Excelsior-488 laser is the LASER ON/OFF control pin
on the Control Interface connector, shown in Figure 16 as the “External
Control Cable Connector”.
When the laser is turned on, it will execute a self-calibration sequence which
typically takes less than five minutes, but may take up to seven minutes. When
this sequence is completed, the laser maintains a fixed output power
according to its factory set point.
There is an INTERNAL/EXTERNAL control switch on the side of the controller,
as shown in Figure 16. This switch is for future functionality and has no
function at present.
Spectra-Physics Excelsior-488 User Guide
25