Download FreeWave Technologies LRS-455 Data Transceiver

LRS-455 Data Transceiver Users Manual
UL NOTIFICATION
Models LRS455-C-U, LRS455-CE-U, LRS455-T-U, LRS455-TE-U are suitable for use in Class 1, Division 2,
Groups A, B, C, and D or non-hazardous locations only. Input voltage for the above models is 6 to 30
volts DC.
WARNING: DO NOT REMOVE OR INSERT DIAGNOSTICS CABLE WHILE CIRCUIT IS LIVE UNLESS THE AREA
IS KNOWN TO BE FREE OF IGNITION CONCENTRATIONS OF FLAMMABLE GASES OR VAPORS.
FCC NOTIFICATIONS
The transceiver is approved under Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Any unauthorized modification
or changes to this device without the express approval of FreeWave Technologies may void the user’s
authority to operate this device. Furthermore, this device is intended to be used only when installed in
accordance with the instructions outlined in this manual. Failure to comply with these instructions may
void the user’s authority to operate this device.
Note: The LRS-455 transceivers are approved for use in Canada within the 450MHz to 470MHz band.
CAUTION:
The LRS-455 series transceiver have maximum transmitted output power of 2W. It is
recommended that the transmit antenna be kept at least 71 cm away from nearby persons
to satisfy FCC RF exposure requirements.
LUM0016AA Rev D
Version 1.0
iii