Download Configuration and Administration Guide

Pfad: C:\Documents and Settings\bhodgson\My Documents\working\Solaris and Linux\4.1A20\SIS41A20\no
changebars\SIS41A20.k08
25. November 2003 Stand 16:31.15
Debugging and troubleshooting
Troubleshooting
The amount of debugging information depends on the setting of debug_level. To
set the level of output at DEBUG for module NU, perform the following steps:
1. After the system prompt, enter the following:
$ dtcpdbg
2. Enter:
level NU DEBUG
I dtcpdbg has no prompt.
8.2
Troubleshooting
Use the following steps for debugging and troubleshooting SIS:
●
Check if CF is functioning and verify that the nodes are up (refer to the CF
installation guide for further information).
●
Use the following command to check if dtcpd is running:
ps -ef | grep dtcpd
●
Verify that the SIS configuration contains the correct nodes and services:
1. Use the dtcpadmin -p command to check the configuration file.
2. Enter the dtcpadmin -r command to reload the configuration.
Dokuschablonen (OECBook) V1.0
by S. Thums OEC MW SQ PS © Siemens Nixdorf Informationssysteme AG 1997
●
Use the following command to verify that the services scheduled are actually
running:
ps | grep [httpd] <service>
●
Use the following command to verify that the VIPs are configured and
functioning:
netstat -ni.
U42120-J-Z100-3-76
135