Download Task Manager Installation and User`s Guide

Transcript
Page 3-2
Chapter Three
3.1THE SUBMIT SWITCHES
The switches are:
/SEQUENCE:n/Revision
switches
Where n specifies an existing queue file entry of
sequence number n. Specifying a sequence number
signals to SUBMIT that you wish to edit an existing
queue entry.
The Revision part of this option
represents a switch or switches that revise the queue
instruction. For example, you may want to change a
permanent
file
to
non-permanent
by
using
/SEQUENCE:n/NOPERMANENT.
/KILL
Removes the specified queue entry from the queue. If
the task is running, the Task Manager will cancel the
task immediately.
/LIST
Lists the contents of the queue file. This is the default if
no control file is specified. If a specific queue entry is
specified, it will list only that entry.
/SUSPEND
Suspends the specified task if it is running. The Task
Manager will cease forcing control file data while the
task is suspended.
/REVIVE
Revives the specified task if it is suspended. Negates
the /SUSPEND switch.
/RESTART
Indicates the specified task is restartable if the system
should crash or be rebooted while it is running. When
the system boots again, the task will restart from the
beginning as though it were resubmitted.
/NORESTART
Indicates the specified task is not restartable. Used to
negate the /RESTART switch. This is the default
setting.
/PERMANENT
Indicates the specified task is a permanent queue
entry. After the task is completed, it will not be
removed from the queue file. The control file should
use the $JOB statement to re-schedule the next run
time.
/NOPERMANENT
Negates the /PERMANENT switch. Default switch.
/LOGTIME
Outputs the current time to the log file at the beginning
of each line of output.
/NOLOGTIME
Negates the /LOGTIME command. Default switch.
DSS-10010-00, Rev. B00