Download Task Manager Installation and User`s Guide

APPENDIX C
ERROR MESSAGES
The following error messages are generated by the TSKINI program, and are displayed only on
the TASK MANAGR job’s terminal. If you want to see these messages to locate problems in
your AMOS32.INI or AMOSL.INI file or your individual job initialization files, you can redefine
the MANAGR terminal to a real terminal. See Chapter 4 for troubleshooting details.
?Command format error
You used a TSKINI command other than B, S, or G in the AMOSL.INI file. Check that file. See
the TSKINI reference sheet for more information.
?Control-C abort
A Control-C was used while running the TSKINI program.
??Fatal error - RES:QFLOCK.SYS not found
The file QFLOCK.SYS was not loaded into system memory at the time of system initialization.
This file is needed by the MAKQUE program in order to create queues. Modify a copy of the
AMOSL.INI file to contain a SYSTEM QFLOCK.SYS line, then MONTST the file, renaming it to
AMOSL.INI if it tests successfully.
?File error during queue file initialization
Not enough queue blocks were allocated—increase the number of queue blocks.
?Illegal command
One of the commands specified in a job initialization command file is incorrect. Check the file
for errors.
DSS-10010-00, Rev. B00