Download D53 Manual

Installation Introduction
11.3 installation instruction
11. 4 Electrification inspection
Use 3pcs screws to integrate the dome and the bracket
connection plate together by turning them 10 degree
clockwise, as shown in the below figure:
Connect video cable and control cable to the other equipments;
Electrify DC12V power.
The PTZ carries on self-checking and executes replacement
procedure after power-on.
In the process of self-checking, camera will rotate horizontally
and slowly for one and half cycle to the default original horizontal
point which is set by factory, then upwardly turn to original vertical
point, then downwardly to original horizontal point. Lens will be
pulled from far focus to near focus to complete self-checking.
The whole camera is absolutely steady means PTZ completed
self-checking and ready to be controlled.
If unstable, please refer to the troubleshooting in the operation
manual appendix.
Picture 1 1.3-1
Integrate the bracket connection plate and the dome
together with the M3*8 screws contained in the accessory
bag, as show in the below figure:
Picture 11.3-2
41