Download User Manual

Transcript
R E F E R E N C E
5.1.7
D E S I G N
There is a lot of deterministic jitter (DJ) on my RocketIO clock signals
Estimate the deterministic jitter on your clock by sending a 101010 pattern over a RocketIO TX
pin, or using an active probe directly on the outputs of the RocketIO differential oscillator.
Routing clocks through FPGA fabric or using a non-MGT clock input will cause a large duty
cycle distortion.
5.1.8
My design works correctly in all the FPGAs except for one
Make sure you are meeting all your design constraints. A marginal timing margin will work in
most FPGAs, but not all.
5.1.9 RocketIO is getting a high bit error rate
5.1.10 RocketIO is not working
5.2 Common Questions
5.2.1
Where are all of the debug pins
DNMEG-300 and DNMEG-400 daughter cards for debug access are available from Dini
Group for a nominal fee.
5.2.2
Where can get the daughter card connectors?
5.2.3
Can I use two Dini Products at the same time?
Dini Group can supply these in small quantity at cost.
The USB utility, AETest_usb can select among any number of Dini Group products at once.
You must run a separate copy of AETest for each board. There is a menu option "change
current device", that lets you switch to another installed device.
The feature will be added to USB Controller soon. Contact [email protected] for
requests.
5.2.4
Do you provide a board description file for ____?
No. Just Certify.
5.2.5
Where is the VHDL reference design?
The VHDL reference design will not be available at the initial release of the DN8000K10. Email
[email protected] for a schedule
•
DN8000K10 User Guide
www.dinigroup.com
194