Download ADMC331 Single Chip DSP Motor Controller
Transcript
ADMC331 TIMING PARAMETERS Parameter Min Max Unit Timing Requirements: tCKI CLKIN Period tCKIL CLKIN Width Low CLKIN Width High tCKIH 76.9 20 20 150 ns ns ns Switching Characteristics: tCKL CLKOUT Width Low tCKH CLKOUT Width High tCKOH CLKIN High to CLKOUT High 0.5 tCK – 10 0.5 tCK – 10 0 Clock Signals tCK is defined as 0.5 tCKI. The ADMC331 uses an input clock with a frequency equal to half the instruction rate; a 13 MHz input clock (which is equivalent to 76.9 ns) yields a 38.5 ns processor cycle (equivalent to 26 MHz). tCK values within the range of 0.5 tCKI period should be substituted for all relevant timing parameters to obtain specification value. Example: tCKH = 0.5 tCK – 10 ns = 0.5 (38.5 ns) – 10 ns = 9.25 ns. 20 ns ns ns Control Signals Timing Requirement: tRSP RESET Width Low 5 tCK1 ns 2 tCK ns PWM Shutdown Signals Timing Requirement: tPWMTPW PWMTRIP Width Low NOTE 1 Applies after power-up sequence is complete. Internal phase lock loop requires no more than 2000 CLKIN cycles assuming stable CLKIN (not including crystal oscillator start-up time). tCKI tCKIH CLKIN tCKIL tCKOH tCKH CLKOUT tCKL Figure 1. Clock Signals REV. B –3–