Download Unix User Guide
Transcript
CHAPTER 9 CUSTOMIZING YOUR S-PLUS SESSION xlsfonts to see a complete list of the fonts available on your screen. As an example, the following resources tells the motif graphics device to use the vg family of fonts ranging in point size from 13 to 40: sgraphMotif*fonts : vg-13 vg-20 vg-25 vg-31 vg-40 Note If you select names that are too long to fit on one line, use multiple lines, and make sure that each line but the last ends with a backslash (\). Since these fonts are intended to list available sizes of the same font, the actual font used is controlled by the current value of par()$cex and the size of the fonts relative to the defaultFont described below. sgraphMotif*defaultFont tells the motif graphics device which font in the *font resource list to use as the default font, when cex=1. Note The fonts are numbered from 0, so that the following resource tells the motif graphics devices to use the third font in the list given by sgraphMotif*fonts: sgraphMotif*defaultFont : 2 sgraphMotif*canvas.width and sgraphMotif*canvas.height control the starting size of the drawing area of the graphics windows. The following resources set the size of the plotting area for the motif graphics device to 800 by 632 pixels. sgraphMotif*canvas.width : 800 sgraphMotif*canvas.height : 632 Note When S-PLUS creates graphics to display in the graphics windows, it uses the initial values of *canvas.width and *canvas.height resources as the size of the drawing area. If you create a graphics device with a small drawing area and later resize the graphics window to a larger size, the resolution of the graphics image is reduced, so that your plots may look blocky. To set color resources for motif devices interactively, we recommend that you use the menus provided in the graphics windows. You can also use the 326