Download E-Sampler Operation Manual

Transcript
For internal battery operation connect the internal battery cable to the battery.
Figure 5 Internal battery connection.
Plug the red wire into the positive side of the battery and the black wire to the
negative side. Plug the three prong connector into the E-Sampler interconnect
board and the unit is operational. Note: this cable has a fuse. If the unit does not
operate on a fully charged battery check the fuse. The part number for a spare fuse
is 590807. For a complete list of spare parts and consumables see section 3.3.6.
For external battery connection connect the external battery cable to the battery
and plug the watertight connector into the bottom of the E-Sampler enclosure. See
Figure 6.
If AC power is available use the universal power supply (UPS). Plug the UPS into
the bottom of the E-Sampler. UPS/External battery connection is shown in Figure
6.
UPS/External
Battery connection
Figure 6 USP/External Battery connection.
When the universal power supply is used with an internal battery it will both
operate the E-Sampler and charge the internal battery. Note: the E-sampler cannot
operate with an external battery and the universal power supply. Both of these
options connect to the E-Sampler at the same location.
E-Sampler-9800 Rev A
Page 15