Download C-PRO GIGA
Transcript
C-PRO GIGA HARDWARE MANUAL 7 Configuration of the supplied analogic outputs signal C-PRO GIGA has four analogic outputs. Each analogic output can be configured to supply one of the following signal : • 0,5-10 V (called voltage) • 0-20 mA (called current) • 4-20 mA (called current). To configurate the signal supplied by the analogic output it is necessary : • positioning the appropriate JMP6 jumper in the selected position (see chapter 2.2 “C-PRO GIGA wiring layout on page 17, jumper and LED meaning ; the configuration jumper is JMP6) • confirming the choice selected with the “controller’s parameters” relative to the analogic outputs as shown on the following paragraph . 7.1 Parameters configuration relative to the analog output By logging on the controller parameters’ configuration procedure relative to the analogic outputs act in the following way : Both for the remote or built-in user interface : 1. Ensure that the controller and the user interface are both switched on and no utilization is connected to the analogic outputs . 2. Keep both and will be visualized. buttons pressed together for two seconds : first available voice 3. Press and release button to select “Parameters”. 4. Press and release button : “Input Password” will be visualized. 5. Press and release button: the cursor blinks. 6. Press and release button to set “ -19”. 7. Press and release button :first available voice will be visualized. 8. Press and release button :further available voice will be visualized. 9. Press and release button to select one of the voice “Type AO1 … AO4”. 10. Press and release button : the cursor blinks. Pag. 40