Download Software Manual - User manual for
Transcript
troubleshooting your machine. Detailed descriptions of scope components are described below. Channel Select • • • • • • • • Channel select drop down menu: Allows you to select which channel you wish to display. Change: This opens a new window so you can use the selected channel to display a signal of your choice. Add Signal: Adds a new channel to the scope (if available) and allows you to select a corresponding signal of your choice. This button will be disabled (grey) if all oscilloscope channels are used. Remove: Removes the selected channel from the scope. Remove All: Removes all channels, resulting in no signals displayed. Signal Scaling: Allows you to adjust the scale in units per division. The type of units used changes depending on the signal chosen. The signal to be scaled corresponds to the channel selected in the channel select drop down menu. Offset: Adjusts the offset of the signal shown in the digital scope display. The offset corresponds to the channel selected in the channel select drop down menu. A list of available channels and their definitions can be found in the Signal Definitions page. Signal Window • • • Channel: Shows the color associated with the channel as seen in the digital scope display Signal: Shows the signal associated with the color and channel. Units/Div: Shows the units per division for the corresponding signal as seen in the digital scope display. 65