Download Software Manual - User manual for

Transcript
troubleshooting your machine. Detailed descriptions of scope components are described
below.
Channel Select
•
•
•
•
•
•
•
•
Channel select drop down menu: Allows you to select which channel you wish
to display.
Change: This opens a new window so you can use the selected channel to
display a signal of your choice.
Add Signal: Adds a new channel to the scope (if available) and allows you to
select a corresponding signal of your choice. This button will be disabled (grey) if
all oscilloscope channels are used.
Remove: Removes the selected channel from the scope.
Remove All: Removes all channels, resulting in no signals displayed.
Signal Scaling: Allows you to adjust the scale in units per division. The type of
units used changes depending on the signal chosen. The signal to be scaled
corresponds to the channel selected in the channel select drop down menu.
Offset: Adjusts the offset of the signal shown in the digital scope display. The
offset corresponds to the channel selected in the channel select drop down menu.
A list of available channels and their definitions can be found in the Signal
Definitions page.
Signal Window
•
•
•
Channel: Shows the color associated with the channel as seen in the digital scope
display
Signal: Shows the signal associated with the color and channel.
Units/Div: Shows the units per division for the corresponding signal as seen in
the digital scope display.
65