1
Download SECTION 2 INSTALLATION - Sea
Transcript
SECTION 2 INSTALLATION ________________________________________________________ 2.8.1 DEFAULT SET-UP VARIABLES As shipped, the user variables for the HSL-CUP4 are set to the following defaults: Brake Wear Compensation: Enabled Desired TDC Stop Position (Mid Speed) Desired TDC Stop Position (High Speed) :N : 000 : 000 Maximum Allowed Stopping Response (degrees) : 300 Cupper Running Speeds: Low Speed (SPM) High Speed (SPM) :100 :250 Lubricator Speed Reference: Maximum Speed Idle Speed (Cupper stopped) : 250 : 075 The “CUP7TMG” timing channel file, as shipped, contains the following default timing set-points: CHAN ON - OFF DESCRIPTION CH00: CH01: CH02: CH03: CH04: CH05: CH06: CH07: CH10: CH11: CH12: CH13: CH14: CH15: CH16: CH17: 120 160 200 120 140 150 140 000 ___ ___ ___ ___ ___ ___ ___ ___ TDC (High) timing TDC (Mid) timing TDC (Low) timing Air Strip (High) timing Air Strip (Mid) timing Air Strip (Low) timing Cup Drop Window timing PLC Timing - 140 180 220 200 220 230 120 020 ___ ___ ___ ___ ___ ___ ___ ___ HSL-CUP4 User’s Manual SYSTEMS Electronics Group - 18 -
