Download User Manual

User Manual
59300235
5.4.2007
AC6951
Rev.002
5(30)
Software
Establishing connection
All the needed configurations and adjustments can be carried out locally or
remotely by using the CATVisor Commander software. Detailed CATVisor
Commander hardware requirements and installation instructions can be found
from the User Manual supplied with Commander.
Connection to AC6951 is possible using the following methods:
Local configuration with PC through standard USB port
Commander 2.7 or later is needed for USB support.
Windows will ask for USB driver when connecting to AC6951 via USB for the
first time. If not found automatically, the driver can be found in 'C:\Program
Files\Common\Teleste\Drivers', select 'telestecdc.inf' file. During
the installation Windows may ask if it should stop the installation. Select
'Continue Anyway'.
Remote IP connection (AC6951 CATVisor software only)
Remote IP connection through a HEC (e.g. DMM201). Transponder IP address
has to be correctly set before remote IP communication is possible. It has to
match the subnet settings of the DMM’s HFC network interface and it must also
be unique for each transponder.
Note that it is also possible to set the IP address remotely through DMM200/201
viewer, see DMM documentation for details.
Remote SNMP connection (AC6951 HMS software only)
AC6951 HMS can be used remotely with SNMP connection through a HMTS.
Some of the communication parameters have to be set locally first.