Download User manual EC

EC-Control User Manual
If you wish to delete a previously set up group, you can do this with Edit/Nodes. .
B.5.2
Adding fans
Using Edit/Add fan(s), you can add a fan, or a whole series of fans, to the active group. The following
dialogue appears:
Fig. B-11
Parental group indicates the group to which the fans are to be assigned. Give your fan any name you
wish. If you wish to set up several fans at once, simply enter the required quantity under Number of
fans. . The fans will then use the name you entered, supplemented by a continuous number sequence.
If * characters are attached to a fan name, these will be replaced with a continuous number sequence. If
the number has fewer spaces than there are * characters, leading zeros will be added.
X and Y indicate the co-ordinates of the top left corner of the first fan to be entered in the room plan
stored for the group. These co-ordinates can easily be identified by moving the dialogue to the side and
moving the mouse over the room plan. The corresponding X and Y co-ordinates are then shown in the
EC-Control status bar. If you generate several fans, the margin in pixels indicates how much space
there is between the fan icons . If you only configure a single fan, you may enter any value you wish,
providing this is greater than zero. If several fans are to be generated, these will always be arranged in
a line. Either horizontal from left to right, or vertical, depending on the selection in the field Direction of
alignment..
While the configuration dialogue depicted in Fig. 3-5 is open, you can simply move the fan icons around
the room plan with the mouse! Simply click on the top left of the area to be moved with the left mouse
button and pull out a red selection panel. Now you can move this using the mouse, together with all the
fan icons it contains.
After you close the dialogue using the Add fan button, the new fans are shown in the tree section
highlighted in yellow.
Individual fans can be deleted as necessary with Edit/Delete node .
Save your changes and restart EC-Control (necessary) to complete the delete process.
84