Download Manual English

Mode Interface Config
13.3.6 ip igmp query-interval
This command configures the query interval for the specified interface. This is the frequency at
which IGMP Host-Query packets are transmitted on this interface. The range for <queryinterval>
is 1 to 3600 seconds.
Default 125 seconds
Format ip igmp query-interval <seconds>
Mode Interface Config
13.3.6.1 no ip igmp query-interval
This command resets the query interval for the specified interface to the default value. This is
the frequency at which IGMP Host-Query packets are transmitted on this interface.
Format no ip igmp query-interval
Mode Interface Config
13.3.7 ip igmp query-max-response-time
This command configures the maximum response time interval for the specified interface, which is
the maximum query response time advertised in IGMPv2 queries on this interface.The time interval
is specified in tenths of a second. The range for <maxresptime> is 0 to 255 tenths of a second.
Default 100
Format ip igmp query-max-response-time <seconds>
Mode Interface Config
13.3.7.1 no ip igmp query-max-response-time
This command resets the maximum response time interval for the specified interface, which is the
maximum query response time advertised in IGMPv2 queries on this interface to the default value.
The maximum response time interval is reset to the default time.
Format no ip igmp query-max-response-time
Mode Interface Config
13.3.8 ip igmp robustness
This command configures the robustness that allows tuning of the interface. The robustness is
the tuning for the expected packet loss on a subnet. If a subnet is expected to have a lot of loss,
the Robustness variable may be increased for the interface. The range for <robustness> is 1 to
255.
Default 2
346