Download Library Executive

Transcript
Chapter 4: Libraries
Creating and Updating Libraries
If the Update only components with matching library name box is selected, Library Executive
searches the source for components whose ComponentLibrary attribute matches the selected
library. Only matched components are updated or added to that library.
When updating a library, the component’s time stamp attribute ModifyDate, if present, is
automatically updated with the current date and time. If the Create component time stamps if
not present check box is selected, and the ModifyDate attribute does not exist, the ModifyDate
attribute is added to the component library.
All attributes that will be updated in the library are listed in the Attribute Conflict Resolution
section.
Read-only attributes cannot be modified and cannot be saved to a P-CAD library. These
attributes are displayed in red on the library Viewer and Query Result Table.
In this section, you can specify how to handle discrepancies between the source and the target
library. Difference handling can be customized for each attribute by the following simple rules:
4.
•
If the Ignore check box is selected, the source attribute is ignored. It is neither created nor
updated in the specified library.
•
If the attribute exists in both the source and the library, and the Source check box is
selected, the source is favored. The source attribute value replaces the present library
attribute value.
•
If the attribute exists in both the source and the library, and the Library check box is
selected, the library is favored. The library attribute value remains unchanged.
•
If the attribute in the source does not exist in the library component and the Ignore check
box is cleared, it is added.
Click OK. The library has been updated to reflect the new attribute values.
Any new components have been added if the Create new components check box was selected.
Refer to Creating a New Library (page 42) for details about the completeness of components
created by the Save To Library command.
Saving a Library
You can create or update a P-CAD library from a variety of sources:
•
a modified P-CAD library
•
an imported library from an external source
•
a query result
•
a cross link result
The only requirement is that you have the primary field, ComponentName, uniquely defined.
44
Library Executive User’s Guide