Download CLASS™ INSTALLATION and SETUP USER MANUAL

5.0 Installation
5.1 Mechanical
5.1.1 Sensor Alignment - Panel Sensors
The panel sensors have two functions: open the door, and protect the door’s edge. So
their positions should be as close as possible to the door edge without intruding into the
non-metal zone. The sensor has about 12 inches of dead zone from its surface and the
beam fan is a 3D cone; aligning the cone axis straight down (as shown below) allows
sensing both the edge and the “touch-to-open” zone.
Bus
Figure 8: Panel Sensor Alignment
MRN 03002-8 TB08-03-192
Page 18 of 34