Download Manual - U.S. Robotics

Transcript
Glossary
ARQ
General term qualifying error correction protocols that detect errors and
automatically re-transmit the incorrect data blocks. See MNP and V.42.
ASCII
Acronym for American Standard Code for Information Interchange. 7 bit
binary code (0 and 1) used to represent letters, numbers and special
characters such as $,! and /.
Bit
A 0 or a 1 reflecting the use of a binary numbering system (a system
that consists of 2 values). This system is used because the computer
only recognizes two states, off or on.
(Start/Stop bits) Signaling bits attached to a character before it is
transmitted; used for asynchronous transmissions.
Bps
The rate in bits per second. Thousands of bits per second are
expressed as kilobits.
Cps
Data transfer rate (Characters per second). It is generally estimated
from the binary rate and the length of characters. For example, at 2400
bits/s, 8-bit characters with a start and stop bit (for a total of 10 bits per
character) are transmitted at an approximate rate of 240 characters per
second (cps). Some protocols, such as the error correction protocols in
the modem use advanced techniques requiring longer transmission
frames and data compression to increase the number of characters per
second.
Flow control
A method that compensates for differences in the data flow coming in to
and going out from a modem or other device. See RTS/CTS and
XON/XOFF
Error correction
Various techniques that check the reliability of the characters or data
blocks. The V.42 and MNP2-2, 10 error correction protocols use error
detection (using a CRC type control code) and re-transmit erroneous
frames (ARQ).
Modem User’s Manual
35