Download SImplIcIty+ - Handicare AS

Transcript
Track assembly
Note: Ensure that the splice bars are positioned
in the track in the correct orientation. The splice
bar has three flat faces and one sloping face.
The sloping face MUST be positioned against
the sloping face on the extrusion (Figure 3).
3If the track is less than 2000mm and cutting
to length on site:
aRemove the charge spring contact
(Figure 4).
bUsing the loading tool, push the plastic
carrier strip up the top section of track
(Figure 5).
Figure 6
Figure 4
Figure 5
4 MINIVATOR SIMPLICITY+ INSTALLATION MANUAL
Figure 7