Download SImplIcIty+ - Handicare AS
Transcript
Track assembly Note: The shorter (square ended stop) must be fitted in the top channel – failure to do this correctly could damage the lift. 17Fit the bottom end cap to the track (Figure 14), ensuring that the power supply cable is fed through the channel provided so that it exits the track on the WALL side. 18Tighten the grub screws to secure the end cap to the track. Figure 13 19Now slide the bottom end stop and final limit stop so that they sit against the positioning extensions of the end cap and then tighten the grub screws (Figure 14). Note: The grub screws on the end cap should not be over tightened. Figure 14 MINIVATOR SIMPLICITY+ INSTALLATION MANUAL 7