Download fulltext - DiVA Portal

Transcript
of the slopes of the larger peaks.
To access this function again, go to the “Preparation” drop down menu, and this time select “Line shape
analysis” located right under the “Define noise level” function.
Once selected, this function
will open a window asking
you to confirm the noise
level number. The number it
displays should be the
number that you had selected
as noise level before.
(Screenshot 10)
Confirm by pressing “OK”
and Amix will clean up all
the noise below your
selected noise level.
Your spectra is now almost
ready to be saved.
There are a number of
functions for editing areas of
the spectra which are
Screenshot 10: The Noise threshold number recived from the “Define noise level
interactivly” function
unwanted, such as peaks
from water or other
solvents. You can remove
these peaks by using the “Delete area” function in the “Preparation” menu. This function will allow you to
highlight an area on the spectra using your mouse. This area will be deleted from the spectra.
There are also functions such as “Remove Positive” or “Remove Negative” which will delete all positive or
all negative peaks from your spectra. The “Keep area” function will ask you to highlight an area which
should not to be deleted, the rest of the spectra will be deleted.
After removing all areas which are not relevant the spectra can be saved to Sbase. To do this select the “Save
to spectral base” function in the “Preparation” drop down menu. A window will appear which will allow you
to define the compound and the experiment type this spectra should be saved to. (Screenshot 11)
75