Download User Manual - CEO Knowledge Center

Transcript
Chapter 6: User Interface Reference
Select Ethernet Setup to configure the Ethernet interface parameters. Consult
your network system administrator for help selecting these parameter values.
Communications Setup Menu
RS-232
RS-232
Channel 0
Channel 1
RS-485
Ethernet
Setup
Setup
Setup
Setup

Select DHCP Disabled to toggle DHCP to the enabled state. When DHCP is
enabled, the eDrive will obtain its Ethernet parameters from a DHCP server on
the network.
Ethernet Setup Menu
DHCP
Set
Set
Set
Disabled
Static IP
Function
Address

Select Set Static IP to set the static IP parameters.
Ethernet Setup Menu
DHCP
Set
Set
Set
Disabled
Static IP
Function
Address

Select Set IP Address to set the IP address.
Static IP Setup Menu
Set
Set
Set
IP Address
Mask
Gateway

Use the selection knob to set each value. Press  or  to switch between
parameters. Select Done to enter the values.
Set Static IP Address
192. 168 .
1 .
46
(Rotate Dial to Change Value – 1x
<-
->
)
Done

© Northrop Grumman Corporation
123
eDrive User Manual