Download Robot Arm Setup & Maintenance

Transcript
5 Maintenance and Inspection
5.3.6 Lubrication
(1) Lubrication position and specifications
The grease nipple position is shown in Fig. 5-17. The lubrication specifications for each place are shown in Table
5-7. Refer to the Page 68, "5.3.2 Installing/removing the cover" for the method of removing and installing the
cover.
<4>Ball screw section application
RH-6FH/12FH/20FH
<2>J2 axis lubrication port
Inside of No.2 arm cover U
Inside of battery cover
<3>Shaft section application
RH-3FH: ball screw spline
RH-6FH/12FH/20FH: ball spline
<1>J1 axis lubrication port
Fig.5-17 : Lubrication positions
Table 5-7 : Lubrication specifications
No.
Parts to be lubricated
RH-3FH series
<1> J1 axis reduction gears
<2> J2 axis reduction gears
<3>
Shaft
(ball screw spline)
Lubrication method
Lubrication oil
Default charge amount
(maker)
Grease nipple
WC-610(Only addition)
4BNo2
(Harmonic Drive Systems Inc.)
Wipe the old grease,
and applies
No-CE specification:
Multemp PS2
(KYODO YUSHI CO., LTD.)
CE specification:
klübersynth UH1 14-222
Lubrication
interval
24,000 Hr
24,000 Hr
Every 2,000km
movement
Lubrication
amount
guide
Cover to
remove
12 g
8g
Battery cover
1g
No.2 arm
cover U
(NOK Kluber Co., Ltd)
RH-6FH series
<1> J1 axis reduction gears
<2> J2 axis reduction gears
<3>
<4>
Grease nipple
WC-610(Only addition)
Shaft (ball spline)
Shaft (ball screw)
Wipe the old grease,
and applies
4BNo2
(Harmonic Drive Systems Inc.)
No-CE specification:
Multemp PS2
(KYODO YUSHI CO., LTD.)
CE specification:
klübersynth UH1 14-222
(NOK Kluber Co., Ltd)
5-88 Maintenance and inspection procedures
24,000 Hr
24,000 Hr
12 g
8g
Battery cover
1g
Every 2,000km
movement
1g
No.2 arm
cover U