1
Download User`s Manual
Transcript
Mediant 800 MSBG Notes: • For a specific IP-to-IP routing rule to be effective, the incoming SIP dialog message must match the characteristics configured for that rule. • The 'IP2IP Routing' table can also be configured using the ini file table parameter IP2IPRouting (see ''SBC Parameters'' on page 858). ¾ To configure SBC IP-to-IP routing rules: 1. Open the 'IP2IP Routing Table' page (Configuration tab > VoIP menu > SBC submenu > Routing SBC submenu > IP to IP Routing Table). Figure 3-107: IP2IP Routing Table Page 2. Add an entry and then configure it according to the table below. 3. Click the Apply button to save your changes. 4. To save the changes to flash memory, see ''Saving Configuration'' on page 336. Table 3-34: IP2IP Routing Table Parameters Parameter Description Matching Characteristics Source IP Group ID [IP2IPRouting_SrcIPGroupID] The IP Group from where the IP-to-IP call originated. Typically, the IP Group of an incoming SIP dialog is determined (or classified) using the ‘Classification’ table (see ''Configuring Classification Table'' on page 198). If not used (i.e., any IP Group), simply leave the field empty. The default is -1. Source Username Prefix [IP2IPRouting_SrcUsernamePrefix] The prefix of the user part of the incoming SIP dialog's source URI (usually the From URI). The default is "*". Note: The prefix can be a single digit or a range of digits. For available notations, see ''Dialing Plan Notation for Routing and Manipulation'' on page 413. Source Host [IP2IPRouting_SrcHost] The host part of the incoming SIP SIP dialog's source URI (usually the From URI). If this rule is not required, leave the field empty. To denote any host name, use the asterisk (*) symbol. The default is "*". Destination Username Prefix The prefix of the incoming SIP SIP dialog's destination URI [IP2IPRouting_DestUsernamePrefix] (usually the Request URI) user part. If this rule is not required, leave the field empty. To denote any prefix, use the asterisk (*) symbol. The default is "*". Note: The prefix can be a single digit or a range of digits. SIP User's Manual 202 Document #: LTRT-12804
