Download Setup and Operation Manual

Flame cutting options
When you select 'Flame' in the 'Type' drop down menu of the 'Tool' dialog box you get
different options which are applicable to flame cutters only. These are described below:
Preheat
The machine will wait for this amount of time to heat up the material before it turns on the
oxygen.
Waterjet cutting options
When you select 'Waterjet' in the 'Type' drop down menu of the 'Tool' dialog box you get
different options which are applicable to waterjet cutters only. These are described below:
Power
Some waterjet cutters have the ability to adjust the power of the jet via software. Use this
box to set the power setting if your machine uses this feature. If your machine does not use
this feature then set this value to zero ('0').
147