Download Keypad Display Configuration User Manual

Transcript
Getting started
Importing an RP file into an existing company
You’ll need to import an RP file into an existing company
whenever:
•
•
You change the configuration of your system
You import a new SDU project into your company
Modifications to the existing SDU project
There may come a time when the configuration of your
company’s system (referred to as an SDU project) is changed or
modified. Any changes to the company, site, buildings,
partitions, or KPDISPs requires an updated RP file. Import the
updated RP file into the existing company and the existing site.
Possible changes include the following:
•
•
•
Changes to the existing hardware of your SDU project
The addition of hardware to your SDU project
The removal of hardware from your SDU project
Importing into an existing company is much the same as
importing a new RP file, except that the imported information
goes into the existing company and existing site. This replaces
the old company information with the new information.
Importing an RP file into an existing company and existing site
has no impact on your existing KDC database.
After the updated RP file has been imported, the KDC displays
your new hardware configuration in the Hardware > System tab.
Note: You can only import an RP file into an existing company
when logged on to the KDC as an administrator.
To modify the existing SDU project:
1. Log on to the system as the administrator.
Tip: Press Alt + F, I, R to
launch the Import
Resource Profile Manager
(RPM) File dialog box.
2. From the file menu, click Import > RPM Configuration
Information.
3. Locate and select the updated RP ZIP file you want to import
and click Open.
If your integrated system installer gave you a floppy disk
containing your RP file, insert the disk and select the RP file
from your floppy drive.
4. Click OK to confirm that the database has been extracted.
5. Select the existing company name.
6. Select the existing site and click OK.
Both company and site are existing, since you are importing
an updated RP file and not a new RP file.
2.14
Technical Manuals Online! - http://www.tech-man.com
Keypad Display Configuration User Manual