Download TidalGuard Sp

Transcript
Preparation for Use
Battery Use and Options
Charging NiMH Rechargeable Battery with External Charger
In a non-patient area, connect the adapter to an AC source, then plug the adapter jack into the charger.
Remove the battery from the TidalGuard™ Sp and insert it into the external charger. The battery will be fully
charged in approximately 4.5 hours. The external charger is for use with the DR30 NiMH rechargeable
battery pack (Cat. No. 400043) only. Refer to the instructions supplied with the charger for additional
information.
DR30 NiMH Rechargeable Battery
(Cat. No. 400043)
Connect adapter
Battery is keyed
to fit into slot in
only one direction
Connect line cord
WARNING
•
The external battery charger should NOT be used to recharge the battery near or in
close proximity to patients and/or other medical equipment in operation. It is intended
for use in service areas only (i.e. nurses station, biomed lab, etc.).
NOTE
•
•
•
•
Rev. B
With a new battery, or a battery that has not been used for 30 days or more, charge the
battery for 24 hours prior to use.
When powered by the external power supply or the BaseStation, the TidalGuard™ Sp will
not overcharge a rechargeable battery.
The monitor may not operate on battery power if the battery is not sufficiently charged.
Dispose of batteries in accordance with local laws.
TidalGuard Sp User’s Manual
13