Download User Manual - Pid Controller

13 Table of Anomaly Signals
If installation malfunctions, controller will switch off regulation output and
will report the anomaly.
For example, controller will report failure of a connected thermocouple
visualizing
(flashing) flashing on display.
For other signals see table below.
#
E-01
E-02
E-04
E-05
E-06
Cause
What to do
EEPROM programming error. Call Assistance.
Cold junction temperature
sensor failure or environment
temperature out of range.
Incorrect configuration data.
Possible loss of instrument
calibration.
Sensor connected to AI1
broken or temperature out of
range.
Sensor connected to AI2
broken or temperature out of
range.
Call Assistance.
Verify that configuration
parameters are correct.
Control connection with
probes and their integrity.
Control connection with
probes and their integrity.
E-08
Missing calibration.
Call Assistance.
E-10
Incorrect control parameters.
Verify control parameters.
E-11
Incorrect alarms parameters.
Verify alarm parameters.
E-12
Incorrect retransmission
parameters.
Incorrect visualization
parameters.
Incorrect remote setpoint
parameters.
Verify retransmission
parameters.
Verify visualization
parameters.
Verify remote setpoint
parameters.
E-13
E-14
53 EN