Download Configuration Editor Software Manual Version 5 Software

Chapter 4 ConfigEd Functions
perhaps its execution load. However, because system operation is dynamic, values below 95% do not ensure that a
module will not crash with an out of heap error.
The Command-SAM Functions
A sub-menu with all the Setup and Monitor (SAM) functions are located under this menu item. The functions are only
active when you connect your PC to a LINK network and after you have generated a CE Module List. The SAM
functions are covered separately in Chapter 6 SAM Functions.
The Command-Comms... Function
You set the communications settings between your PC and a LINK network or between your PC and a telephone
modem through this menu selection. The settings in this menu and communications between your PC and LINK
networks in general are discussed in Appendix A Communications.
The Command-Revisions (#)... Command
Any time ConfigEd executes a save, it creates a new revision file for any configuration
you have functionally modified or whose appearance you have altered. This allows you
to recall early revisions of the same configuration (see File-Open History above).
Revisions(#)... sets the quantity of revisions of a configuration ConfigEd saves
in from the current to the oldest. The larger the number, the more current the revision.
Current
number of
revisions
4
To change the number of revisions ConfigEd saves, go to the Command menu and select
Revisions (#).... A dialog box will ask you to set the desired number of revisions. Enter
a number and click OK. The parentheses shows current set number of revisions. The
default number is three. If you save more than the set number of revisions, the oldest
existing revisions are deleted. For instance, if you set your number of revisions for
TTTpro to three and then open, modify and close the configuration four times, the
Applications that appears when you click on Open History... will make only the last
three revisions available.
Configuration Editor Software Manual
4 - 31