Download ProtoCessor Design Guide

ProtoCessor Design Guide
Page 6 of 34
1.4.4 FFP-LON ProtoCessor (FPC-ED4)
Ethernet port for
Diagnostics and Host or
Field protocol support
LonWorks port (2-wire)
for Field LonWorks
protocol support
LonWorks Service Pin
To commission chip
1.5
ProtoCessor TTL Socket Supporting RX and TX
signals – 5VDC
ProtoCarrier Daughter cards
These cards are designed for OEM’s with boards that are not designed to accommodate a ProtoCessor TTL socket.
The ProtoCarrier is able to be attached to any of the available ports (RS-232; RS-485; RS-422; KNX; M-Bus; Ethernet
or LON, and translate to any RS-232 or RS-485 or Ethernet or LonWorks or KNX or M-Bus field protocol.
ProtoCarrier
Data
Boards
FPC-C34
FPC-C35
FPC-C36
FPC-C37
FPC-C38
FPC-C39
FPC-C40
FPC-C41
FPC-C42
FPC-C43
Interface Connections
RS-232
RS-485
2
1
1
1
1
1
1
1
RS-422
1
1
Ethernet
1
1
1
1
1
1
1
1
1
1
LonWorks
Certifications
KNX
M-Bus
1
BACnet BTL
LonMark
Yes
Yes
Yes
Yes
1
Yes
Yes
1
1
1
Yes
1
1
1
1
Yes
Yes
1.5.1 ProtoCarrier FPC-C34 - 2 RS-485 and 1 Ethernet Port
RS-485 end of line
configuration switch
DIP Switches for setting
MAC Address, Node-ID,
Baud Rate
Ethernet port for
Diagnostics and Host or
Field Protocol support
RS-485: +/- and G
Power: +/- and FG 9-30 Vdc
or 12-24 Vac
ProtoCessor 1991 Tarob Court Milpitas, California, 95035 USA Web: www.protocessor.com
Tel: (408) 964 4433 Fax: (408) 964 4425 Toll Free: (800) 317 8319 email: [email protected]