Download ACS SASSI - ghiocel

Transcript
ACS SASSI PREP User Manual
197
KMOD,<e1>,[<e2>],[<step>],<nd>
assigns the BEAMS K node to <nd> for all elements between <e1> and <e2> (default: <e1>)
with step <step> (default: 1) from the active group.
Note: the active group must be of type BEAMS.
5.3.21.
Define a Soil Layer
L,<nm>,<thick>,<weight>,<pveloc>,<sveloc>,<pdamp>,<sdamp>
defines the soil layer number <nm> with thickness <thick>, specific weight <weight>, P-wave
velocity <pveloc>, S-wave velocity <sveloc>, P-wave damping ratio <pdamp>, and S-wave
damping ratio <sdamp>.
Note: Soil layers may be assigned to excavated soil elements (see MSET instruction - section
5.3.30) or may be used to define soil layering or halfspace properties for the ACS SASSI SITE
module (see Options / Analysis command - see section 3.5.6).
5.3.22.
List Soil Layers
LLIST,<m1>,[<m2>],[<step>]
lists the table of soil layer properties between <m1> and <m2> (default: last defined) with step
<step> (default :1).
5.3.23.
Define a Material
M,<nm>,<val1>,<val2>,<weight>,<pdamp>,<sdamp>,<type>
defines the material number <nm>. If <type> = 1, <val1> is the elasticity modulus and <val2>
is the poisson coefficient; if <type> = 2, <val1> and <val2> are the constrained and shear
moduli; and if <type> = 3, <val1> and <val2> are the P- and S-Wave velocities. For all cases,
<weight> is the specific weight, <pdamp> is the P-wave damping ratio, and <sdamp> is the Swave damping ratio.
Note: <pdamp> and <sdamp> must be equal for materials assigned to SHELL elements.
5.3.24.
Set Active Material / Soil Layer Index
5. INSTRUCTION SET
© Copyright 2014 by Ghiocel Predictive Technologies, Inc.
197