Download ACS SASSI - ghiocel
Transcript
ACS SASSI PREP User Manual 197 KMOD,<e1>,[<e2>],[<step>],<nd> assigns the BEAMS K node to <nd> for all elements between <e1> and <e2> (default: <e1>) with step <step> (default: 1) from the active group. Note: the active group must be of type BEAMS. 5.3.21. Define a Soil Layer L,<nm>,<thick>,<weight>,<pveloc>,<sveloc>,<pdamp>,<sdamp> defines the soil layer number <nm> with thickness <thick>, specific weight <weight>, P-wave velocity <pveloc>, S-wave velocity <sveloc>, P-wave damping ratio <pdamp>, and S-wave damping ratio <sdamp>. Note: Soil layers may be assigned to excavated soil elements (see MSET instruction - section 5.3.30) or may be used to define soil layering or halfspace properties for the ACS SASSI SITE module (see Options / Analysis command - see section 3.5.6). 5.3.22. List Soil Layers LLIST,<m1>,[<m2>],[<step>] lists the table of soil layer properties between <m1> and <m2> (default: last defined) with step <step> (default :1). 5.3.23. Define a Material M,<nm>,<val1>,<val2>,<weight>,<pdamp>,<sdamp>,<type> defines the material number <nm>. If <type> = 1, <val1> is the elasticity modulus and <val2> is the poisson coefficient; if <type> = 2, <val1> and <val2> are the constrained and shear moduli; and if <type> = 3, <val1> and <val2> are the P- and S-Wave velocities. For all cases, <weight> is the specific weight, <pdamp> is the P-wave damping ratio, and <sdamp> is the Swave damping ratio. Note: <pdamp> and <sdamp> must be equal for materials assigned to SHELL elements. 5.3.24. Set Active Material / Soil Layer Index 5. INSTRUCTION SET © Copyright 2014 by Ghiocel Predictive Technologies, Inc. 197