Download 6 signalling systems

Transcript
171
RATO 6.6 Technical section
6.6 TECHNICAL SECTION
A structural subsystem to be used in the railway system must have
commissioning approval issued by Finnish Transport Safety Agency.
A structural factor in use, associated with signalling elements or signalling
systems must have approval or permission for field test issued by Finnish
Transport Agency.
The requirements of the signalling systems manufacturer must be taken into
account when installing the signalling system and planning the installation.
6.6.1 Mechanical parts of the signalling system
The signal or signal lamp unit must be directable.
The signal or the signal lamp unit must be directed in such a way that the signal
aspect is visible from the signal for the distance according to the signal sighting
requirement, as well as in rear of the signal for as long as possible over the
distance that begins at the signal and ends at the distance of the sighting distance
requirement from the signal (fig 6.6:1).
Signal aspect must be visible altogether at least on half of
this stretch and on as long part as possible
Signal aspect must be visible at some
point on this stretch
10% of the required sighting
distance
Aspect must be
visible on this
stretch
¼ of the required
sighting distance
Required sighting distance
Figure 6.6:1 The visibility of the signal aspect on the distance according to the
sighting distance requirement.
6.6.1.1 Installing the signalling apparatus
The signalling apparatus must be installed outside the structure gauge (ATU) of
the track that the signalling apparatus is installed on and the adjacent track in
such a way that the signalling apparatus with its installation tolerance is located
outside the ATU. In relation to the main track, the main track ATU must be
used, the side track ATU must be used for the side track and the broad-gauge
track ATU must be used for the broad-gauge track. When installing a signalling
apparatus on a broad-gauge track or next to it, the ATU of the main or side track
of the broad-gauge track in question can be used if the signalling apparatus is
positioned inside the broad-gauge track ATU, and the signalling apparatus can
be easily removed or transferred outside the broad-gauge track ATU. The ATU
and its possible gauge widenings must be taken into consideration according to
the requirements stated in RATO part 2, “Track Geometry”.
RATO 6 2009-12