Download 6 signalling systems
Transcript
69 RATO 6.3 Interlocking system – – – the track section in advance of the shunting signal which starts the main route is vacant, if the distance between the shunting signal, which is closest to the main signal connected to shunting signals and the main signal is at least 300m, the track section in advance of the shunting signal which starts the main route becomes occupied, if the distance between the shunting signal, which is closest to the main signal connected to shunting signals and the main signal is a distance of less than 300m, or the track section in advance of the shunting signal which starts the main route is vacant, if the main signal connected to shunting signals cannot be seen from any of the shunting signals connected to the main signal in question. 6.3.6 Shunting route 6.3.6.1 Setting a shunting route It must be possible to set a shunting route between two consecutive shunting signals through all paths made possible by the route points between the shunting signals in question. The shunting route conditions are the same as the main route conditions exclusive of the exceptions stated here. The shunting route must end at – a main signal, – a block signal, – a shunting signal, – a track equipped with a line block system on the line, – a track section where the track vacancy proving ends, or – a track section, at whose boundary a board limiting the shunting work will be positioned. A shunting route must be set without flank protection. A shunting route must be set without overlap. The shunting route must become set, even if its track sections are occupied. It must be possible to determine the track vacancy proving of specified track sections in the basic shunting route conditions. Setting a shunting route in such a way that the route entry signal of the shunting route to be set is the route exit signal of a set main route, must be prevented during the checking of the basic route conditions. The displaying of an aspect permitting driving of signals included in the shunting route must be on condition that the locking and monitoring conditions for a shunting route are fulfilled. RATO 6 2009-12