Download Manual - Optimum Data Inc.

Configuration
Automatic Configuration for Selected Frame Relay Discovery Mode (2 of 4)
If the mode selected is . . .
Then setup configuration is . . .
H 1MPort
H Management PVCs: 2
(cont’d)
For Management PVC
information: see Table 8-12,
Management PVC Options.)
– Name is automatically created from the network
DLCI as Mgmnnnn (nnnn being the discovered
multiplexed network DLCI number). 2
Example:
Network DLCI 1001 →
Port-1 DLCI 1001 and
Mgm1001
– Intf IP Address is taken from the Node IP
Address. 2
– Intf Subnet Mask is taken from the Node Subnet
Mask. 2
– Primary Link is set to Net1-FR1.
– Primary DLCI is automatically created from the
network DLCI.
– Primary EDLCI is set to 2 (management data).
– Set DE is set to Enable.
– RIP is set to Proprietary.
(For PVC Connection
information: see Table 8-10,
PVC Connection Options.)
2
8-14
H PVC Connections:
– Source Link set to Port-1.
– Source DLCI – Port-1 DLCI is automatically
created.
– Source EDLCI is left blank.
– Primary Destination Link is set to Net1-FR1.
– Primary Destination DLCI is the automatically
created network DLCI.
– Primary Destination EDLCI is set to 0.
If the same DLCI/EDLCI combination already exists, no changes are made to the
existing management PVC.
You may want to configure a unique Node IP Address and Subnet Mask, and create a
management PVC for this address and subnet mask prior to Frame Relay Discovery.
May 1999 - Preliminary
9124-A2-GH30-00