Download Manual - Optimum Data Inc.

Configuration
Automatic Configuration for Selected Frame Relay Discovery Mode (3 of 4)
If the mode selected is . . .
Then setup configuration is . . .
No Management:
H DLCI Records :
H 1Port
(For DLCI Record information:
see Table 8-9, DLCI Records
Options.
– Network: DLCI Number is automatically created
from the LMI status response message.
Port-1: DLCI Number is automatically created
from the network DLCI.
Example:
Network DLCI 1001 →
Port-1 DLCI 1001
– Network: DLCI Type is set to Multiplexed. 3
– Network: CIR (bps) is automatically determined
from LMI status update message if switch
provides this information. Otherwise, the port
rate is configured.1
Port-1: CIR (bps) is set to the network DLCI’s
CIR.
– Committed Burst Size Bc (Bits) is set to the
network DLCI’s CIR.
– Excess Burst Size Be (Bits) is set to the network
port rate minus the network DLCI’s CIR.
– DLCI Priority is set to High.
(For PVC Connection
information: see Table 8-10,
PVC Connection Options.)
H PVC Connections:
– Source Link set to Port-1.
– Source DLCI is automatically created from the
LMI status response message.
– Source EDLCI is left blank.
– Primary Destination Link is set to Net1-FR1.
– Primary Destination DLCI is automatically
created from the network/source DLCI.
– Primary Destination EDLCI is set to 0
(Port-1 data).
1
The port rate is calculated at the time of discovery as the number of DS0s allocated to
frame relay. It is automatically configured once for each DLCI. Should the number of
DS0s change, this value must be manually recalculated and changed via the
Configuration branch.
3 When non-FrameSaver units are at the other end of the PVC connection, change the
network DLCI Type setting to Standard before sending data.
9124-A2-GH30-00
May 1999 - Preliminary
8-15