Download Manual - Optimum Data Inc.

Transcript
SNMP MIBs and Traps, and RMON Alarm Defaults
Dynamic DLCI Alarm Defaults – NetScout Area
These alarms apply to DLCIs on the network interface. They are created either
during RMON initialization or when a DLCI is created, and put into the
NetScout-defined alarm area. They will be reconfigured if the interface’s line
speed changes.
Table D-6. Dynamic DLCI Alarm Defaults – NetScout Area
Item
Rx DLCI Link
Utilization
Sample
Type 1 MIB/Tag/OID 2
D
Interval
MIB: FT DTE MIB (RFC 2115) 60 secs.
(1 min)
Tag: frCircuitReceivedOctets
Event
Type
Rising
Falling
Threshold Threshold
Default
Default
Rising
70% of link 65% of link
capability
capability
Rising
70% of link 65% of link
capability
capability
OID: .1.3.6.1.2.1.10.32.2.1.
9.I.D
Tx DLCI Link
Utilization
D
MIB: FT DTE MIB (RFC 2115) 60 secs.
(1 min)
Tag: frCircuitSentOctets
OID: .1.3.6.1.2.1.10.32.2.1.
7.I.D
1
D = Delta. Indicates that the calculated difference between the current value and the previous value is contained
in the MIB.
A = Absolute. Indicates that the exact value for the item is contained in the MIB.
2
I in the OID = Interface ID of the frame relay link.
D = DLCI number.
9124-A2-GH30-00
May 1999 - Preliminary
C-21