1
Download User manual - software
Transcript
5.4.6 Analysis graphics „Vehicle end geometry and coupler deflection” Legend Window with sampling resultes (only during sampling active) Vehicle contour always of the same vehicle Figure 76: Analysis graphics „Vehicle end geometry and coupler deflection” The analysis graphics „Vehicle end geometry and coupler deflection“ may be displayed in the modes – Display in the curve (see above), – Display in s curve, as well as – Display in inclined rail, which may be selected upon the command „Analysis type“ of the context menu or the „Analysis“ menu, as well as the corresponding buttons on the toolbar. If the calculation results in a vehicle middle offset greater than the value allowed by the coupler’s operational length, the user is informed adequately. For the single modes, different results are displayed in the legends: DIMA user manual Page 107 of 150
