Download User manual - software


Height for new calculation positions
Additional height
Add / delete
additional heights
Define vertices of reference
profile as standard heights
Figure 90: Dialog „List of heights for new calculation positions“
For the output positions to be defined (X co-ordinates, ni, na values), it is possible to
declare heights, at which the width reduction is output. These may be the vertices of the
vehicle construction gauge, on the one hand, and selected height points, on the other
hand:
The definition of standard heights has to be performed before declaring the
corresponding X co-ordinates / ni, na values of the cross sections.
The standard heights are applied to all cross sections created in the following.
All heights at the vehicle are understood as heights at unworn and unloaded
vehicle and are related to the top of rail (RS). The associated deflections
(empty-loaded, overload) and wear sizes have to be input.

Delete whole module
With this command, all defined output positions for the selected module are deleted.
DIMA user manual
Page 117 of 150