Download GigaLog S - ControLord

Transcript
8.8 Configuration, Commands
Other pages allow you to change many important configuration values, like inputs, sampling, and time.
You may also use the serial interface (Rs232, or USB) to configure the LCD.
lm <mode>,<contrast> mode= 100 Graphic LCD, mode=101 Graphic with simulated input values
grt=<language>,<channels>,<channels per page>,<seconds>,<minutes>,<hours>,<days>,<bits>,<start>
<start>= 11=Log data sec, 12=min...; 21=Scope 1ms, 22=2ms,.. 30=Bar graphs, 40=Installation
100=personal page (See programming manual)
gr<ch>= <input>,<show>,<min>,<max>
grb[<n>]=<in0>,<ins>,<min>,<max>
Bar graph page
gre[<n>]=<in>,<style>,<x>,<y>,<wd>,<ht>,<min>,<max>
Installation bar graph
gry= [c][b][l][i][t][s] Graphic display user no access to c= configuration, b= bargraphs, l=log data, i=installation, t=
command terminal, s= change state Go Stop.
grc=<ch> Change page, put channel into foreground.
grw <color>,<text> Set headline message. Colors are 0=red, 1=green, 2=blue, 3=yellow, 4=cyan...
<color>= 100 + color: wakeup sleeping LCD.
For special characters sequences see chapter Configuration Special characters.
grpop <time>,<text> Display pop-up message for <time> seconds. A | in the text indicates new line.
gri <filename> Load installation background image from file to internal Flash memory. Image must have same size,
width and 16 colors.
grx Refresh screen.
grp <filename> Print to file.
gra Calibrate touchscreen.
grlp=<timeout>,<mode>
groff Cut power supply graphic display. See grlp mode.
gron Establish power supply graphic display. See grlp mode.
Ram usage: (<seconds>+<minutes>+<hours>+<days>) * <channels> * 2/3/4 bytes. 2/3/4 bytes for 16 bit, 24 bit, or
32 bit mode resp.
Quick Start
z
lm=101
www.controlord.f
GigaLog S 1401
44