Download CMI RII User Manual

Check In/Out in Teamcenter
Read from Teamcenter
Update Teamcenter
CMI Info
Restore Session
Synchronize Teamcenter
Highlight in Teamcenter
Save Session
Browse in Teamcenter
Create/Attach an Archive
Get original geometry from Teamcenter
Insert from Teamcenter
Replace from Teamcenter
Manage Catalogs
Reconnect with Teamcenter
Build Visualization
Compare Version
AddTemp from Teamcenter
Figure 65: CMI Toolbar in CATIA V5
With the CMI toolbar it is possible to read files from the CMI RII application in Teamcenter.
You can then modify the geometry in your CATIA V5 session. The modifications can be
updated in Teamcenter via the Update Teamcenter or the Synchronize Teamcenter button
in CATIA V5.
The icon Highlight in Teamcenter is only active if you are working with a product structure.
You can get the Teamcenter information of the CATParts, CATProducts, CATDrawings,
and CATIA V4 Models with the CMI Info button if you loaded the product structure with
CMI to CATIA V5.
The other commands will be described in more detail later in this chapter.
CATDrawings in CMI RII Application in Teamcenter
CATIA V5 will read all expanded assemblies, single CATDrawings from the Teamcenter
CMI RII application.
The following figure shows a CATDrawing in the CMI RII application:
48
CMI RII User Manual