Download ADC Hardware Control Panels

Adc Hardware Control Panels
Installation Reference


Ingest Control Panel
<Shift><CueSOM> - Split Segment
<Shift><CueEOM> - Combine Segments
Note: The above mappings are the default settings. Any function, both new and existing, can
be mapped to any button, either as the un-shifted or shifted behavior.
The “Shift+” state latches when the Shift button is pressed as follows:
•
If the Shift button is pressed and held, and another button is pressed, that button’s
"Shift+” action is invoked. It is also possible to continue to hold the Shift button and
press additional buttons, each of which will invoke its "Shift+" action. If one or more
buttons are pressed while the Shift button is held down, when the Shift button is
released the shift state will be cancelled.
•
If the Shift button is pressed and released, the shift function is latched and the next
button that is pressed will provide a "Shift+" action. Once a button is pressed, the
shift state will be cancelled.
•
If the Shift state is currently latched and the Shift button is pressed again- before
another button is pressed, the shift state will be cancelled.
To Configure Actions and Shift+ Actions for a button on ICP
1. From the Media Client main menu select Properties > Control Panel. The Control Panel
selection dialog is displayed.
2. From the Control Panel selection dialog select the desired Control Panel from those listed
in the left pane, and then click Edit. The Control Panel configuration dialog is displayed.
3. Select the ICP tab.
There are three columns displayed- “Button”, “Action” and “Shift+ Action”.
•
The “Button” column indicates the physical labeling of the buttons on the ICP
•
The “Action” column indicates what action the button will perform when the Shift state
is not latched.
•
The “Shift+ Action” column indicates what action the button will perform when the
shift state is latched.
2014 Imagine Communications
Proprietary and Confidential
8-December-2014 | Page 42 of 50