Download Instruction Maunal

ENT
▼
ENT
When setting the controller,
parameter G.IN and G.Out
should be setting up prior to
any others
……
▼ or ▲
ENT
H.OUT Value
ENT
US1,US2 can be setting up
by Operator for modifying
parameters and set up in
G.CTL refer to Table of
D-Register as attached
in this manual
(*note 1: Display ‘STOP’ when operates stopping.)
- it can be able to change SP Value when STOP operates)
(*note 2: Operation Display-1 : Initial display after power on ; can set SP value.)
(*note 3: Operation Display-2 : Output Control Display.)
(*note 4: Heating Output Display in H/C type.)
(*note 5: Cooling Output Display in H/C type.)
(*note 6: When User Screen-1 is registered.)
(*note 7: When User Screen-2 is registered.)