1
Download AMI Configuration Commands Reference Manual
Transcript
AMI Configuration Commands 1.10.4.8.7 Displaying Traffic on a Series D Network Module This command lets you display traffic information about the Series D network modules. Enter the following parameters: myswitch::configuration module traffic d> show Cell Module Memory Model UBR EFCI EFCI AAL5 EPD EPD On Off PktCnt AltVC Thresholds CLP0+1 CLP1 1A 256Kx32 2 14717 14717 256 192 disable 4080 256 1B 256Kx32 1 14717 14717 256 192 disable 4080 256 1C 256Kx32 3 14717 14717 256 192 disable 4080 256 1D 256Kx32 3 14717 14717 256 192 disable 4080 256 The fields in this display are defined as follows: Field Description Module The network module that has been configured. Cell Memory The size of this shared memory cell RAM configuration (x32). Model The shared memory model used for this network module. See conf module traffic d models for more information. EPD The AAL5 packet drop threshold for CBR, VBR, and ABR traffic on this network module, in cells. UBR EPD The AAL5 packet drop threshold for UBR traffic on this network module, in cells. EFCI On The threshold value at which the EFCI bit will be set (turned on), signalling congestion, for all traffic, in cells. EFCI Off The threshold value at which the EFCI bit will be cleared (turned off), indicating no congestion for all traffic, in cells. AAL5 PktCnt enable means the network module counts the number of transmitted AAL5 PDUs. disable means the network module does not count the number of transmitted AAL5 PDUs. The default is disable. AltVC Threshold CLP0+1 The alternate threshold at which cells are dropped, regardless of their CLP bit, when the current cell count for a connection is greater than this threshold. This threshold is used instead of the VC CLP0+1 threshold if the conf port traffic d altclpconfig command is applied or if it is enabled using the -AltCLP option under conf upc new. AltVC Threshold CLP1 The alternate threshold at which cells that are CLP=1 are dropped when the current cell count for a connection is greater than this threshold. This threshold is used instead of the VC CLP1 threshold if the conf port traffic d altclpconfig command is applied or if it is enabled using the -AltCLP option under conf upc new. 1 - 164 AMI Configuration Commands Reference Manual
