Download AMI Configuration Commands Reference Manual

AMI Configuration Commands
1.19.2.2 Creating a PNNI SPVC
This command lets you create a PNNI SPVC. Enter the following parameters:
You do not need to open a session to the
destination switch to create a PNNI SPVC
because all PNNI SPVCs are bidirectional.
NOTE
myswitch::configurat spvc pnni> new <port> <vpi> <vci> <destnsap | destprefix:destport>\
AMI Configuration
Commands
[-spvcid <index>] \
[-domainid <id>] \
[-name <name>] [-destvpi <vpi> -destvci <vci>] \
[-reroute (enable|disable)] \
[-fupc <index>] [-bupc <index>]
advanced options:
[-ftpnniDtl <index>] [-bearerClass (X | A | C)] \
[-clip <no|yes>] \
[-QoSExpIndex <index>]\
[-fqos (class0 | class1 | class2 | class3 | class4)] \
[-bqos (class0 | class1 | class2 | class3 | class4)]
Note: <destprefix:destport> option can be used only if the destination
switch is a FORE switch.
The parameters for delete and new are defined as follows:
Parameter
Description
SPVC ID or -spvcid <index> The index number assigned to this SPVC to identify it uniquely. For PNNI SPVCs, the
index number may be assigned either by AMI or by the user. Valid values are integers
between 1 and 65535.
port
The port number on the source (local) switch fabric.
vpi
The virtual path number on the source (local) switch fabric.
vci
The virtual channel number on the source (local) switch fabric.
destnsap
The ATM NSAP address of the destination (remote) switch for this SPVC.
destprefix:destport
The ATM NSAP prefix and the port number of this terminating SPVC at the destination
end. This option is valid only if the destination switch is a FORE switch.
-domainid <id>
The PNNI domain ID number on the source (local) switch fabric.
-name <name>
An optional name for the user to assign to this PNNI SPVC to help uniquely identify it.
-destvpi <vpi>
The virtual path number on the destination switch fabric for this PNNI SPVC. When using
this option, both the destvpi and destvci must be specified.
AMI Configuration Commands Reference Manual
1 - 303