Download PC-InfoNode User`s Guide

10
5560 QOS
Trending Tabs
The following tabs are known as trending pages: Metering, Revenue, Demand, Adv. Energy, Adv. Metering, Unbalance,
Harmonics, Flicker, and Adv. Harmonics. These pages contain an enable/disable checkbox at the top of the page. The
purpose of the checkbox on any trending page is to enable trending of properties and values listed on that page. If the
box is checked, the settings on that page go into effect. If the box is not checked, the remaining settings are persisted but
are not in effect. Trending pages are available only for Custom EN50160 Compliance Setup. Trending pages are hidden
under Strict EN5160 Compliance Setup.
5. Metering tab
Properties
Values
Basic Metering (Metering, MMXUO)
Line-Neutral Voltage (A-N)
Line-Neutral Voltage (B-N)
Line-Neutral Voltage (C-N)
Neutral-Ground Voltage
Line-Line Voltage (A-B)
Line-Line Voltage (B-C)
Line-Line Voltage (C-A)
Line Current (A)
Line Current (B)
Line Current (C)
Line Current (N)
Active Power (A)
Active Power (B)
Active Power (C)
Total Active Power
Enable Periodic Sampling
High-High limit enabled
High-High limit
High limit enabled
High limit
Low limit enabled
Low limit
Low-Low limit enabled
Low-Low limit
Deadband enabled
Deadband
Enable Trending (This page)
;
Select the journal entry/entries to change
Apparent Power (A)
Apparent power (B)
Apparent Power (C)
Total Apparent Power
Power Factor (A)
Power Factor (B)
Power Factor (C)
Average Power Factor
Angle Between Phases (A)
Angle Between Phases (B)
Angle Between Phases (C)
Frequency
phase-to-neutral
or phase-tophase values
displayed here
depend upon
the Wiring
Configuration
set under the
Basic tab
;
…
112.49
…
154.16
…
87.50
…
75.00
…
2.50
Under ENABLE TRENDING (THIS PAGE) is a checkbox in the value field opposite Basic Metering. The box
enables the trending of values listed in Metering page. If
the box is checked, the settings on the page go into effect.
If the box is not checked, the remaining settings are persisted but are not in effect.
Under SELECT THE JOURNAL ENTRY/ENTRIES TO
CHANGE, the various phase-to-neutral and phase-tophase parameters are displayed. High and low limits can
be enabled and individually set for each phase-to-neutral
and phase-to-phase value. Note however that the available
phase values depend on the Wiring Configuration selected
under the Basic Tab. For instance, for wye circuits L-N,
10-30
Signature System InfoNode on PC User’s Guide