Download CryoJane User Manual

Absolute Alcohol
The following items are required for installation:
Hair Dryer
Gauze
Gloves
01 Remove release paper
from ECU
02 Place ECU on top left
corner of cryostat
03 Using absolute alcohol and gauze
clean chamber wall
04 Heat left wall for
Mech/Flash Unit & Oil Bath
placement Also heat the
exposed adhesive on the
mounting plate and oil bath
05 Place Oil Bath towards the
rear of the left chamber wall
06 Route Oil Bath & Mech/Flash Unit
Cables underneath Mech
*07 Place Mech/Flash Unit in
Chamber.
Place Mech/Flash Unit low in
chamber near the front wall.
(Placement near the freeze
bar is ideal in most cryostats)
08 Route cables in door bar
09 Place door bar with cables
onto front chamber ledge.
If required attach Door Bar Support Strip
underneath door bar
3