Download Metabolomics Workflow Guide

Transcript
Advanced operations
2. Select the entity list and
interpretation in Find
Minimal Entities (Step 1 of
10).
Analysis
a Click Choose to select the Entity List. By default, the active entity list is selected
and shown in the dialog. It is recommended to select an entity list that has been
at least filtered on flags.
b Click Choose to select the Interpretation. By default, the active interpretation of
the experiment is selected and shown in the dialog.
c Click Next.
Figure 175 Entity List and Interpretation page (Find Minimal Entities (Step 1 of 10))
3. Select the algorithm in Find
Minimal Entities (Step 2 of
10).
a Select a Choose selection algorithm. The possible values are Forward selection
algorithm, Backward elimination algorithm, and Genetic algorithm.
If you click Forward selection algorithm, then after you click Next, the Forward
Selection Parameters page (Step 3 of 10) is displayed (page 171).
If you click Backward elimination algorithm, then after you click Next, the Backward Elimination Parameters page (Step 4 of 10) is displayed (page 172).
If you click Genetic algorithm, then after you click Next, the Genetic Algorithm
Parameters page (Step 5 of 10) is displayed (page 173).
b Click Next.
Figure 176 Choose Selection Algorithm page (Find Minimal Entities (Step 2 of 10))
4. Select and enter the
forward selection algorithm
parameters in Find
Minimal Entities (Step 3 of
10).
If you selected the Forward Selection Algorithm in the Choose Selection Algorithm
page (Find Minimal Entities (Step 2 of 10)), then this step is where you specify the
algorithm parameters.
a Type the Target size for features. You must enter the target size of the features.
By default the value shown is one tenth of the total entities. This value must
equal the number of features you select in “Choose your features in Find Minimal
Entities (Step 7 of 10).” on page 177.
b Select an Evaluation metric. The possible values are Overall Accuracy and Min
Class Accuracy.
c Type the Target metric value. The default value is 100.
171